my shower faucet is leaking from hot water side through the cold water side. It’s too corroded to tell the size. Can’t afford a plumber to come out, right now. I turned the hot water off, that’s how I know its on the hot water side. They (both sides) have been changed before but they weren’t the correct size either. Had a plumber tell me they would have to change out everything behind the wall and that’s why I can’t afford them right now.

Always Be On the Alert For Signs of a Possible Leak

 

A leak in your home can be something that goes unnoticed for a long time until signs begin to show through the paint, the rotting the wood, or when it’s time for the bucket brigade. Slow leaks or leaks that occur unnoticed for long periods can also cause mold to grow, adding to the problem by causing an environmental problem and costing you even more in aggravation, time, and money. Always be on the alert for warnings signs of a possible leak. Follow these guidelines and check for signals that will keep your kitchen and bathroom in check and free from leaks.

 

1.      Fix and Change Worn Parts

Damaged parts are a major cause of leaks and wasted water in a bathroom or kitchen. Look over the following parts regularly, and repair or replace them if they are worn.

·        Inspect the washers in the shower head- Check for water dripping or spraying out from the threaded area of the head.

·        Tub diverters can waste a lot of water. If it is leaking into the tub, it may be time to replace it with a new one.

·        Toilet tanks – Check for any leaks between the tank and bowl. If there is water leaking, tighten the bolts that hold the two together, being careful not to tighten them too much. Also, make sure there is no water leaking between the bowl and floor. You can usually tell this by a wet spot on the floor around the bowl and/or a dark mildew on the floor around the bottom of the bowl usually in the grouted tile joints.

·        Toilet flapper valve – A faulty flapper can waste hundreds of gallons of water. Flappers are simple to replace and can be purchased at your local home improvement store or plumbing supply. Make sure to turn the water supply off and remove the flapper. Put it in a plastic bag and take it with you to match up its’ shape with a new one.

·        Rotted washers and bolts around toilet tanks and an insufficient wax seal can result in a rotted floor. This can go unnoticed for a longtime until one day the floor begins to look a little crooked or uneven. Don’t let this go without further inspection. It’s time to call a professional.

·        Faucet washers – can result in a high water bill and can also ruin and de-laminate mica counter and vanity tops if they go unnoticed. Replacing countertops can run well into a few thousand dollars.

·        Check for leaks at supply lines to toilet bowls, sinks, dishwashers, hot water dispensers and refrigerators. Supply line valves may not be used for some time and once there are turned a seal can be broken and a leak may begin.

·        Check for sediment build-up in faucets and showerheads. These can stifle water pressure. Periodically remove the strainers on you faucets and remove any sediment that may be collecting. In most cases this will drastically improve your water pressure. In areas with hard-water it may be necessary to do this more frequently.

           

2.      Inspect the Caulking and Grouting

Caulking is very important in preventing a leak and keeping water from infiltrating vulnerable places. Caulking should be somewhat flexible, and not be cracked or blackened with mildew—if it is, don’t just use any caulk, replace it with a tub and tile type silicone based waterproof caulking.

Check the following areas for cracked or missed caulking in need of repair.

·        Around the bottom of the toilet

·        Along wall at the edge of the tub or shower

·        At the inside corners of the tub or shower

·        Between the countertop and backsplash

·        Where the tub meets the shower

·        At the base of the tub or shower along the floor

·        Where the shower door meets the wall and tub or shower base.

·         

           

3.      Knowing When to Call in the Professionals

There are some things that need to be fixed by professionals in order to avoid future or even more damage. Call a plumber if you find the following problems and feel as though you are in over your head,

·        Leaky or stuck water supply lines and valves

·        Leaking shower heads, or other leaks that you can’t fix

·        Leaks present in the shower pan

·        Trouble with mold or mildew on the walls.

 

To get your copy of Hector’s book,

 

What Your Parent’s Never Told You About Owning a Home

 

Visit www.americashomeimprovementcoach.com and with

 

your purchase his book you will receive 5 reports on

 

ü     Selling Your Home In Any Market

ü     Hiring the Right Contractor For You

ü     Staying Within Your Budget

ü     Looking Out For Contractor Scams

ü     What Questions Should You Ask a Potential Contractor

 

My lease says:

“Within 10 days of the date of this lease, the tenant shall notify the landlord of any problems with the range, fridge, or air conditioning unit…..any repairs needed after 10 days shall be attributed to normal wear and tear and is the sole responsibility of the tenant.”

Yes, I signed it, but can he really make me pay for any of this stuff? Also…..

“In addition, the tenant recognizes that items such as window cranks, aluminum mechanical parts, faucet washers, internal toilet parts, will from time to time wear out due to normal wear and tear…The replacement and/or repair of all internal plumbing, such as stopped up sinks, leaky pipes, leaking toilets, leaking showers/faucets, and plugged drains shall be the sole responsibility of the tenant.”

Do I really have to pay for plumbing issues? I thought the landlord HAD to upkeep certain things, by law.
Within a month of moving in, the oven coil went out and he wouldn’t replace it, so I had to buy one online for $40. BTW, the oven is old as heck, probably 1970-ish.

My toilet has had problems since I moved in. I called once before the 10 days and all he did was come over with a plunger. Didn’t call a plumber or anything. The toilet doesn’t flush right more than half the time – sometimes I have to dump a bucket of water in it, and I have to plunge it almost everyday at least once.

Looking For Plumbing In Yorba Linda Call 714-527-6300
Save Water, Save Money

Water is scarce. Water prices are rising. If the Cap and Trade bill passes then water useage costs will skyrocket.

Let Mr Rooter® Plumbing show you the way to preserve our most valuable resource, water.

Ask your service professional how you may fit within the qualification requirements for state and Fed discounts while improving the potency of your home.

During our visit, we will give a water-wise survey of the pipes and plumbing in your home. This helps you locate opportunities where you can preserve water and economize instantly.

We will show you how to:

* test your water meter
* Judge your plumbing fixtures for water savings
* Measure your flow rates on shower heads, taps and aerators
* take a look at your water heater efficiency.

Mr Rooter service professionals plumbers can identify areas of potential that can exist in turning your home into a “green” environment. We intend to also show you straightforward methods to save water both inside and outside your home.

Leaks and wasting water can sometimes be costly – from increasing your water and sewage bills to adding to the cost of heating your home’s of how it’s possible to ask for a prioritized list of how you can start using water as efficiently as possible. It will help you save 10-20% of the water you now use.

Water Conservation Checklist

Best Plumbers

Indoors

* Fix leaky toilets and fixtures as soon as they are detected
* Take fast showers instead of full-tub baths
* Don’t keep the water running while brushing your teeth, shaving or washing your face
* Put a plug the sink when rinsing fruits and vegetables
* Run your dishwasher and washing machine only with full loads
* Use correct water level settings for laundry
* Install on demand hot water dispenser
* Install low-flow toilets, showerheads and faucet aerators
* Consider a re-circulating hot water system
* When replacing washer, consider a front load unit ( uses 30 percent less water and 50% less energy than a top load unit)
* Flush toilets and use garbage disposals only when necessary
* take a look at your water meter monthly for possible leaks
* Use water remaining in drinking glasses to water plants
* Perform maintenance on water heater annually

Expert Plumbers

Outdoors

* When washing vehicles, employ a nozzle that turns off automatically
* Use drought-tolerant plants in the garden
* Know where your master water shut off valve is found and show everyone in the household
* Test the water shut off valve frequently to ensure it works
* Position sprinklers so they don’t seem to be spraying the house, sidewalks, street or driveway
* Don’t water when it is windy
* Maintain your sprinkler system as it suffers from ordinary wear and tear, which reduces the efficiency
* Sweep instead of hose off paths, terraces, decks and driveways
* Cover swimming pools when not in use to stop evaporation
* Mulch flower beds to keep soil cooler and reduce water loss
* Turn off sprinkler systems during cool or rainy weather
* Contact your water service district for a personalized irrigation schedule
* Check pressure-regulating valve

If you’re in Garden Grove and other nearby cities and there is blockage in your drain, clogged sewage lines, damaged toilet, clogged toilet – don’t fool around with dubious plumbers. Call your own Mr Rooter, the national name you trust to take care of all your plumbing needs.

There’s a reason Mr Rooter is the biggest and swiftest expanding full service plumbing and drain company in the country. With 24-hour service, free guesstimates, fixed rate pricing and professional technicians, there’s just no reason to call anyone else. Mr. Rooter might not always be the least expensive plumber in town, but we’ll always be the most talented and professional. We’ve proudly been serving the San Gabriel Valley since 1990 and most of our plumbers have been in the business for nearly two decades.

Plumbing Professionals
Hiring a plumber isn’t as simple as just picking up a telephone book and picking one. You need to ensure that you get a certified plumbing contractor and not some hack. To increase your percentages of selecting a good plumber there are some questions that you must ask. Continue reading this article to discover what those questions are.

The first query that you should ask is, “How long have you been a plumber?” This is a vital question because if a plumber has been in business for a considerable time they are more likely to be good – Mr Rooter has been servicing your community for 20 years

The next query you must ask is, “Are you insured?” If they are insured this suggests that you and your home is protected in the case of an unfortunate incident. If they are not insured then they are just not terribly pro and you must pass on using them.

A third query to ask is, “Do you offer a written guarantee?” A qualified cleaner will have no problem backing up their work with a written guesstimate. If they won’t offer you a warranty you should be right away nervous about their quality.

One last query you should ask is, “Do you have any references?” Id you are doing a large extensive plumbing job you should ask for references. IF they can not give you at least some good references it’s a few good references it is a bad sign. Once you get the list of references be certain to basically call them. You may be stunned how many corporations give out fraudulent references or give out names of people who weren’t even happy with the work.

Mr Rooter gets passing grades on all of these questions with flying colors! Ask us the hard questions – Then you will know you found the right company.

Looking For Plumbing In Yorba Linda Call 714-527-6300
.

For damp-proofing a brick foundation wall, heavy penetrating bituminous damp-proofing paint may be used, after which a cement mortar coat may be troweled directly on the painted surface, to prevent the paint from flaking and peeling.

The application of a coating of any material upon the inner surfaces of a wall such as a home sauna that is pervious to the sauna steam is generally ineffective. Infrared saunas need no such coating anyway.

This should be made of 1 part Portland cement and 3 parts of well graded sand mixed with as little water as practicable. The mortar should be applied to the dampened wall after the leakage through the wall has stopped. The finished coat should be kept damp for a week after it has set to increase its water-tightness.

Fresh air and sunshine are essential to a dry cellar, and to this end plenty of window space should be provided. When the air out of doors is cool and dry, open the windows freely. When there is dampness without, keep the windows closed, as warm, moist air results in mildew and condensation of moisture upon the colder surfaces within the cellar. A little care in these respects will aid materially in maintaining a dry cellar.

When there is dampness within, such as in bathrooms, windows should be kept open. Shower doors are not enough to protect against steam shower condensation. They do a fabulous job of keeping water inside, but steam will inevitably get out.

Cracks or fissures in foundation walls and the falling out of mortar from between joints may be attributed to various causes. Cracks between mortar and the material to which it was originally bonded may be caused by shrinkage of the mortar during setting, or soon thereafter, or by the expansion of mortar through saturation.

Often the volume change of the mortar is greater than the material to which it is bonded and sets up a movement that destroys the bond. If the walls are built on ground that will not support an equal weight at all points, uneven settlement may cause cracks to develop. An underground spring or flowing water under one corner or section of a foundation may produce similar results.

Small cracks thus started may become larger in time from action of the weather and other forces. Frost has a tendency to attack weak spots, and expansion and contraction, due to extremities of heat and cold, do their part in increasing the damage. Water seeping through the cracks gradually wears away the material and causes it to crumble and fall apart. The disintegration is generally more rapid in mortar joints.

The results of these failures are far-reaching and, if not remedied, may result in further damage, not only to the walls themselves but to the structure they support. A cellar will probably become damp and unsanitary if these inlets for moisture are not stopped up. There can also be drippage from the bathroom to rooms below, due to a leaky bathtub or bathroom faucet.

If the walls are otherwise in good condition, minor cracks and places where mortar has fallen out may be repaired by an unskilled workman. However, if a wall is badly cracked, crumbled and beyond the aid of minor repairs, it may be necessary to engage an experienced workman to reconstruct all or part of the wall.